KTI Off Road

Recently our Cherokee (XJ) started to develop problem with back up lights – they worked erratically, then stopped to work at all. Two months later problems with starting showed up – sometimes I had to move the lever to N position to make starter working. Diagnose: dying neutral safety switch. Pretty common problem for AW4 transmissions – both mounted in Jeep as well as those in Volvo. Fortunately most of the time you can easily fix it without spending $200 on new one or scarifying backup light feature or having to start your car in N position.

When you crawl beneath your Jeep on the passenger side you will see something like this:

(…More…)

Technorati Tags: Cherokee, XJ, back up lights, neutral safety switch, AW4, Jeep, Volvo

Time has come to lift up our Cherokee (XJ) a little bit. After carefully browsing offers I decided to equip it with 3″ lift kit from IROC upgraded with full leaf springs from Procomp. Installation process is quite easy and straight forward. Everything is well described in the installation manual. Except of one thing – how to unbolt leaf spring front bolt.

Jeep’s engineers did really great job here – they welded the nut inside frame rails. Why is it a problem? Because during the years of life rust slowly glues together bolt with the inner steel sleeve of the leaf’s bushing. When you have access to the nut you can unbolt it and then carefully tap the bolt to loosen it out. When the nut is welded inside the rail the only way to take it out is loosen the sleeve on the bolt beforehand. How to achieve it?

First you have to loosen the rust inside the but. They were kind enough to leave inspection openings in the rails. Using them you can spray the nut with some good penetrating oil. The goal is to be able to turn the bolt about half of the turn. And not screw the thread. In my case it took about 5 sprays over 2h to loosen the rust enough to turn the bolt about one turn. Then the real fun begins.

Armored with die grinder with cutting wheel cut off the leaf spring just next to the bushing ear. Then turn the sandwich (ear, bushing and bolt) about half turn and cut it again into two halves. The result is shown below:

(…More…)

Technorati Tags: Cherokee, XJ, leaf springs, front bolt, Jeep

As you may have noticed some time ago we figured that worn out ball joints in our XJ are a reason for annoying death wobble constantly bugging our car. Recently we got some queries about how difficult this task is to perform by average garage mechanic, so here it is – small how to replace them. this Procedure apply to all Jeeps that have front Dana 30 axle: Cherokees (XJ), Grands (ZJ) and Wranglers. Probably more or less to any car, but I didn’t try it there so no warranties.

First, before you even start a list of special tools you will definitely need. All of them usually can be rented out from your local parts store. You will need tie rod end separator, good torque wrench, ball joint replacement set and a slide hammer. Be prepared for leaving there quite a nice deposit – but it will motivate you to finish the job quicker and get your deposit back sooner .

To make things easier and faster jack your car up and take off both front wheels. Safety first – chock your rear wheels and use good jack stands to hold your front up in the air.

Then unbolt brake caliper (12mm bolts shown on the picture) and carefully hand them somewhere out of your way.

Be careful not to stretch (nor hang them by) brake lines. (…More…)

Technorati Tags: ball joints, replace, Jeep, Dana 30, Cherokee, XJ, ZJ, Wrangler